Spring and cable work
Garage door spring repair in Tupelo
The bang from the garage, the door too heavy to lift, the cables hanging slack. That is a spring job, it is the most common repair there is, and it gets fixed in one visit.
How you know the spring is broken
Most people hear it go: a single loud bang from the garage, often at night or first thing on a cold morning, with nobody near the door. After that the symptoms stack up fast.
- The opener strains, lifts the door a few inches, and gives up
- The door feels like dead weight when you pull the red release cord and lift by hand
- A visible gap of an inch or two in the coil of the spring above the door
- Lift cables hanging loose or wound off their drums
- The door slams the last few feet instead of settling
Stop using the opener once you suspect a broken spring. The motor is not built to lift the door's full weight, and forcing it turns a $250 spring job into a spring job plus a stripped opener.
Torsion spring replacement, done properly
The spring above your door is wound under load with steel bars, never guessed at. A proper replacement matches the spring's wire size, diameter, and length to the door's actual weight, then sets the tension so the door balances: lifted halfway by hand, it should stay put.
While the shaft is apart, the center bearing, end bearings, and drums get looked at, and the lift cables get replaced if they show fray. Doing that work in the same visit is cheap; doing it as a second service call next month is not. Extension-spring doors, the older style with springs along each horizontal track, get safety cables run through the new springs so a future break stays contained.
Garage door cable repair rides along
Cables and springs are one system. When a spring breaks with the door up, the cables usually jump their drums, and a door with one jumped cable hangs crooked in its tracks. The fix is the same visit: re-seat or replace the cables, level the door, then set spring tension. If your door is crooked and jammed right now, skip to emergency repair or call (662) 407-6162 straight away.
Spring questions, answered straight
How much does garage door spring replacement cost in Tupelo?
Plan on $220 to $350 for both torsion springs on a standard two-car door, parts and labor. One-car doors and single-spring setups run less. Replacing both springs at once is standard practice: they were installed together, they wear together, and the second one is living on borrowed time once the first lets go.
Can I replace a garage door spring myself?
This is the one garage door job worth paying for even if you fix everything else yourself. A wound torsion spring stores enough energy to lift a 150-pound door, and it releases all of it instantly if a winding bar slips. The tools are cheap; the emergency room is not.
How long do garage door springs last?
Springs are rated in cycles, not years. A standard spring is good for about 10,000 opens and closes, which is seven to ten years for most households. A door that runs four or more times a day, or one that carries kids and dogs in and out all summer, uses its cycles faster. High-cycle springs cost a little more and roughly double the life.
Why did my spring break in cold weather?
Steel gets brittle as temperatures drop, and the hard freezes that reach north Mississippi a few times each winter are when tired springs finish cracking. If you hear the bang on the first cold morning of January, your spring was already near the end; the cold just picked the date.
Free estimate, Tupelo to the county line
Tell us about the bang. Get the spring price.
Say what it did, what it sounded like, and whereabouts you are. The callback comes with a price, not a pitch. Phones answered faster than forms: (662) 407-6162.
- The price quoted on the phone is the price on the invoice
- A car trapped behind a dead door jumps the schedule
- When a $12 roller is the fix, nobody quotes you a new door